Skip to main content
Skip table of contents

Auto-selection using calibration groups

This page applies to Harlequin v13.1r0 and later; both Harlequin Core and Harlequin MultiRIP.

This section describes how to group calibrations so as to allow the RIP to select the calibration that best matches the halftone in use. This is done by passing the setcalibration operator a type 6 dictionary (rather than type 5, which does not allow auto-selection of calibrations from a group).

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.