Skip to main content
Skip table of contents

Font handling

This page applies to Harlequin v13.1r0 and later; both Harlequin Core and Harlequin MultiRIP

The Harlequin RIP will normally use fonts embedded in a job if they are present, and will use a font by the same name that has been installed into the RIP’s SW/fonts or SW/CIDFont directories if no font is embedded in the job.

This behavior may be configured in several ways, as described below:

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.