Skip to main content
Skip table of contents

HqnImpose2 suffixes

This page applies to Harlequin v13.1r0 and later; both Harlequin Core and Harlequin MultiRIP.

Any defined Suffix procedure is called after the objective and tactic procedures. In most cases, use them to complete work started in a Prefix procedure. They could also be used to produce step-and-repeat output based on the page positions calculated by the Objective and Tactic .

As with objectives and tactics, the value of /Suffix should be either a key referring to an existing procedure or a PostScript-language procedure.

The following pre-defined suffixes are included in the procset:

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.