Skip to main content
Skip table of contents

Other DCS configuration items

This page applies to Harlequin v13.1r0 and later; both Harlequin Core and Harlequin MultiRIP.

These configuration items define what the procset should do in cases where data is missing or not an exact match.


This defines what should be done if a separation is included in the DCS file but is not produced on output. The possible values are:


If any of the separations present in the DCS file is not produced, use the low-resolution composite in the main file instead of the high resolution.


If any separation is present in the DCS data, but is not produced by the RIP, skip that separation but use all the other high-resolution separations.


This defines what should be done when the high-resolution data is in an external single-file DCS2 file, and the %%PlateFile comments do not match those in the embedded header in the job itself. The possible values are:


Carry on regardless, using the values from the external file


Report the issue and continue.


Abort the job.


This defines what action to take if the high-resolution data is missing. The possible values are:


Image the low-resolution data


Leave blank


Abort the job.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.