Skip to main content
Skip table of contents

Setting up a hotfolder to shut down the Scalable RIP

This page applies to Harlequin v13.1r0 and later; and to Harlequin Core but not Harlequin MultiRIP

When running with hotfolder input enabled, it is useful to set up a second input folder to be able to quit the RIP cleanly. Add the following page feature as SW/Page Features/Quit:

                          /HqnConfigProvider /ProcSet findresource /quitrip get exec

Then start the RIP with two hotfolders, one for jobs, one for quit PS jobs only:

                          mkdir input quit output
                          C:\apps\HHR_SDK_dev> bin\clrip -m 4096 -C -c MyFarmConfig -nrips 4
                          -f output\%j-%p.tiff -H input -F Quit -H quit

Jobs dropped into the input directory will process normally using config MyFarmConfig . Any file (even zero-length) dropped into the quit directory will cause the Scalable RIP to shut down cleanly.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.