Skip to main content
Skip table of contents

Using the error handler

This page applies to Harlequin v13.1r0 and later; both Harlequin Core and Harlequin MultiRIP

In most cases the most efficient method of using the error handler is by installing it in a page feature. Two sample page features which show long and short format reports are included as SW/Page Features/Examples/Error Handler – Long and ~Short . Obviously, these cannot be used as they stand to debug problems with other page features; to do that similar code could be added to a file run at RIP start up, or into the top of the problem page feature.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.