Skip to main content
Skip table of contents

(v13) D_PLUGIN_INITIALISE (PostScript device plugins)

This page applies to Harlequin v13.1r0 and later; and to Harlequin MultiRIP but not Harlequin Core

D_PLUGIN_INITIALISE Selector

Parameter: PlugInitParam *param

Call type: Singleā€call

This is the third startup call made to the PSDEV plugin. It is used to set up any state required by the plugin as a whole. D_PLUGIN_INITIALISE is followed by a call to D_SECURITY .

TEXT
      typedef struct plugInitParam { int32 version ;
      int32 memAllocated ; int32 returnCode ;
    } PlugInitParam ;

Note: By this point, the globalState pointer in the GenericPluginContext structure passed to the plugin will have been correctly initialized.

version

The version field should be ignored.

memAllocated

The RIP sets this to indicate the amount of global memory actually allocated in response to the amount requested in the D_IP_BOOT call.

If this is less than the amount requested (usually zero if it is), the plugin may refuse to boot by setting returnCode , below, appropriately.

returnCode

The plugin should set returnCode to CONTINUE_BOOT if the memory allocated is sufficient and the plugin can continue to operate. If not, it should set it to ABORT_BOOT , after which the plugin boot is aborted, and the plugin is ignored.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.