Skip to main content
Skip table of contents

(v13) FilmLeft, FilmTop, FilmRight, FilmBottom for HqnImpose2


This page applies to Harlequin v13.1r0 and later; both Harlequin Core and Harlequin MultiRIP.

By default pages will be separated from each other within an individual flat by the gutters described above, but their outer edges might run right up to the limits of the imaging area. They may be moved in by specifying margins around the edge of the film. This can be particularly useful for adding additional information (for example, as a film slug in a FilmOverlay procedure; see below). The margins are defined by setting values for the keys: /FilmLeft, /FilmRight, /FilmTop, and /FilmBottom . Specify values s in points.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.