Skip to main content
Skip table of contents

(v13) How to remove the Harlequin Core SDK Linux

This page applies to Harlequin v13.1r0 and later; and to Harlequin Core but not Harlequin MultiRIP.

This section describes how to remove the Harlequin Core SDK from your Linux machine. You must be superuser.

  1. Navigate to /Uninstall Harlequin Core SDK XX.X/.
  2. Double-click Uninstall Harlequin Core SDK XX.X followed by Run. Alternatively, in a terminal window run the file Uninstall Harlequin Core SDK XX.X, which starts the InstallAnywhere uninstall process.
  3. In the “Introduction” screen, click the Uninstall button. An “Uninstalling” message appears.
  4. A “Removing ldk” dialog appears, which allows you to select:

    Uninstall the RIP only
    (which leaves the LDK installed)
    Continue (which uninstalls both the RIP and the LDK), and
    Cancel (which aborts the uninstall).

  5. Make a selection to continue.
  6. When the Uninstall Complete message appears, click the Done button.

The uninstall procedure does not remove files that were created after the installation.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.