Skip to main content
Skip table of contents

(v13) WaitTimeout (system and user params)

This page applies to Harlequin v13.1r0 and later; both Harlequin Core and Harlequin MultiRIP

Param

Val

ExType

Vers

Use?

HPS

Ref

S,U

i

A

Y

All

The system parameter indicates the value in seconds to which the user parameter WaitTimeout is initialized at the beginning of each job. A value of 0 indicates that the timeout is infinite. Any attempt to set the system parameter WaitTimeout to a negative value is ignored and the previous setting of WaitTimeout is used.

Values: 0 or any positive integer.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.