Skip to main content
Skip table of contents


This page applies to Harlequin v13.1r0 and later; both Harlequin Core and Harlequin MultiRIP.

We recommend that you check that the LDK daemons are running on Linux using:

sudo /etc/init.d/aksusbd status

which should report:

AKSUSB daemon is running!

WINEHASP daemon is running!

HASPLM daemon is running!

If they are not started, start them using:

sudo /etc/init.d/aksusbd start

You can stop them using:

sudo /etc/init.d/aksusbd stop

The Admin Control Center (ACC) is only available when the Linux daemon is running.

To install the LDK run-time on Linux open a terminal window, make yourself superuser and go to:

<HHR install path>/ldk

This is usually:



  1. Copy /ldk/ to /var/hasplm/
  2. Use the following to install the runtime:

rpm -i aksusbd-n.n-n.i386.rpm

(replace the n characters to match the version present).

A message appears, stating that the runtime is installed or a package is already installed.

GGSL recommends using the latest LDK runtimes, which are available on the GGSL ftp site.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.